For whom: Panel Administrator, SRE. Required rights: Administrator session.
Status of individual samples
Each inspection returns one of the statuses below: “not applicable” status means that no verification is required for this purpose.The statuses
not_required, absent, skipped, not_implemented, unsupported are service states and do not increase the severity of nodes.WARP status
For WARP, a separate set of states is used:installed, missing, port_closed, unreachable, pending_install, not_required, unknown. If WARP is not required by the circuit assembly plan, the status is not_required, not a failure.
Summary states
Sample statuses are reduced to the general state of the node, circuit or entire park:Severity and incidents
The level of severity of the incident is deduced from the consolidated state:How the state of the node develops
The panel combines three signals - the state of the node in Remnawave, the results of health checks and the heartbeat of the agent:- critical — Remnawave reports that nodes
disconnected; or agentoffline; or network reachabilityunreachable/failed. - degraded — Achievability
timeout/dns_failed/port_closed; or agentdegraded; or servicefailed/timeout/degraded. - healthy - achievability and service
ok/not_implementedor serviceokwith an online agent. - unknown is nothing definite yet.
Freshness and Flow version
The draft, the version used and the observed health are displayed separately. The checks relate to the working image; the presence of the applied version does not make Flow healthy without sufficient checks. The absence of a proven client pass can leave the state ofunknown or degraded even with available nodes.
The late result of the old version does not replace the current one. Use the latest information from the current version to restore it. Diagnosis of Flow.
Quorum of input nodes at the connection scheme
For the connection scheme (Flow), the summary takes into account the roles of nodes - input (entry) and transit (transit) - and works by quorum:Example: in a balanced circuit with three input nodes, the failure of one of them gives degraded, and not critical - the remaining two hold more than half the capacity.
Summary throughout the park (global dashboard)
The global state on the dashboard becomes critical when the node, circuit or route becomescritical. The offline agent maximizes the state to degraded; the availability of the node is separately checked by network samples. The state of healthy requires at least one healthy entity and no degraded/critical signals; the empty installation gives unknown.
Causes of failure (classification “why”)
In addition to status, the system captures the cause: the unavailability of the gateway, the fall of the input or transit node, the stop of the service part, the missing agent, the configuration drift, the incorrect conditional connection, the absence or closed WARP port, the inaccessibility or refusal of the authorization of the proxy, the inaccessibility of the source of the CDN, the DNS mismatch, the expired TLS, the failure of the external regional sample, the waiting for target selection and “unknown.” Reconstruction.Verification
Open Health and press Run check. Summary status and causes are displayed on the dashboard cards.Rollback
Change operations (confirmation of recovery action, node suppression) and their rollbacks are described on the pages of Restoration and Node Suppression.Typical errors
Accepted the unknown for failure.
Accepted the unknown for failure.
unknown means “no data yet,” not “bad,” and after the first run of checks or manual run, the state will be clarified.Expected critical, and the scheme degraded
Expected critical, and the scheme degraded
Partial loss of inputs can be degraded when the quorum is saved, but the loss of the required minimum of pool participants or sustained end-to-end failure can be critical; see the reason for the particular check.
Offline agent, and dashboard's not red.
Offline agent, and dashboard's not red.
That’s what it’s designed to be: an offline agent doesn’t raise the global state above degraded. The node’s real inaccessibility will be independently demonstrated by its reachability tests.
