Skip to main content
The status of the node combines Remnawave status, the results of the checks and the heartbeat of the agent, and control is performed on the page of a specific node.

Statuses

Update.

  1. Open Nodes and select the server.
  2. Click Update on the right side of the header.
  3. Wait for the check to be completed.
  4. Check status, heartbeat and fresh events on the tab Review.
To check the entire park, open the list. Nodes and press Run the check..

Remove the node from traffic

  1. Open the node page → Settings.
  2. Change Traffic status to draining.
  3. Press Save.
  4. Open those using the Flow node and remove it from the respective input or transit blocks.
Employment is indicated by a warning in the Flow constructor. There is no separate employment table in the panel.

Get the node back to work.

Open up. SettingsGet the old one back. Traffic statusSave the changes and press Update in the title of the page.

Remove the node

  1. Make sure that node is no longer assigned to Flow blocks.
  2. On the node page, click Delete.
  3. Check the data in the dialogue and confirm the action.
If the node is still in use by the circuit, the panel will block the deletion and show dependence. Go back to the corresponding Flow and change the binding.
Recovery of the remote node via the interface is not provided. For temporary maintenance, use draining.

Verification

After status change, open OZZZOURZ: the new label should be displayed in the title, and the action should be displayed in the tab Journal.